Ip Ospf Retransmit-Interval - SMC Networks SMC6724L3 Management Manual

Command Mode
Interface Configuration (VLAN)
Default Setting
1
Command Usage
• Set the priority to zero to prevent a router from being elected as a DR
or BDR. If set to any value other than zero, the router with the highest
priority will become the DR and the router with the next highest
priority becomes the BDR. If two or more routers are tied with the
same highest priority, the router with the higher ID will be elected.
• If a DR already exists for an area when this interface comes up, the new
router will accept the current DR regardless of its own priority. The
DR will not change until the next time the election process is initiated.
Example
Console(config)#interface vlan 1
Console(config-if)#ip ospf priority 5
Console(config-if)#

ip ospf retransmit-interval

Use this command to specify the time between resending link-state
advertisements (LSAs). Use the no form to restore the default value.
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
seconds - Sets the interval at which LSAs are retransmitted from this
interface. (Range: 1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
5 seconds
IP R C
OUTING OMMANDS
4-269