Version - SMC Networks SMC6724L3 Management Manual

Command Usage
This command can be used to configure a static neighbor with which
this router will exchange information, rather than relying on broadcast
messages generated by the RIP protocol.
Example
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#

version

Use this command to specify a RIP version used globally by the router.
Use the no form to restore the default value.
Syntax
version {1 | 2}
no version
• 1 - RIP Version 1
• 2 - RIP Version 2
Command Mode
Router Configuration
Default Setting
RIP Version 1
Command Usage
• When this command is used to specify a global RIP version, any
VLAN interface not previously set by the ip rip receive version or ip
rip send version command will be set to the following values:
- RIP Version 1 configures the unset interfaces to send RIPv1
compatible protocol messages and receive either RIPv1 or RIPv2
protocol messages.
- RIP Version 2 configures the unset interfaces to use RIPv2 for both
sending and receiving protocol messages.
• When the no form of this command is used to restore the default
value, any VLAN interface not previously set by the ip rip receive
version or ip rip send version command will be set to the default
send or receive version.
IP R C
OUTING OMMANDS
4-235