Host - SMC Networks SMC6724L3 Management Manual

host

Use this command to specify the IP address and network mask to
manually bind to a DHCP client. Use the no form to remove the IP
address for the client.
Syntax
host address [mask]
no host
• address - Specifies the IP address of a client.
• mask - Specifies the network mask of the client.
Default Setting
None
Command Mode
DHCP Pool Configuration
Usage Guidelines
• Host addresses must fall within the range specified for an existing
network pool.
• When a client request is received, the switch first checks for a network
address pool matching the gateway where the request originated (i.e., if
the request was forwarded by a relay server). If there is no gateway in
the client request (i.e., the request was not forwarded by a relay server),
the switch searches for a network pool matching the interface through
which the client request was received. It then searches for a manually
configured host address that falls within the matching network pool.
• When searching for a manual binding, the switch compares the client
identifier for DHCP clients, and then compares the hardware address
for DHCP or BOOTP clients.
• If no manual binding has been specified for a host entry with the
client-identifier or hardware-address commands, then the switch
will assign an address from the matching network pool.
• If the mask is unspecified, DHCP examines its address pools. If no
mask is found in the pool database, the Class A, B, or C natural mask
DHCP C
OMMANDS
4-113