Command Mode
Interface Configuration (VLAN)
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• This command defines how long any responder (i.e., client or router)
still in the group has to respond to a query message before the router
deletes the group.
• By varying the Maximum Response Interval, you can tune the
burstiness of IGMP messages passed on the subnet; where larger
values make the traffic less bursty, as host responses are spread out
over a larger interval.
• The number of seconds represented by the maximum response
interval must be less than the Query Interval (page 4-207).
Example
The following shows how to configure the maximum response time to
20 seconds:
Console(config-if)#ip igmp max-resp-interval 20
Console(config-if)#
Related Commands
ip igmp version (4-210)
ip igmp query-interval (4-207)
ip igmp last-memb-query-interval
Use this command to configure the last member query interval. Use the no
form of this command to restore the default.
Syntax
ip igmp last-memb-query-interval seconds
no ip igmp last-memb-query-interval
seconds - The report delay for the last member query. (Range: 1-255)
M
F
ULTICAST
ILTERING
C
OMMANDS
4-209
Need help?
Do you have a question about the SMC6724L3 and is the answer not in the manual?