Dhcp Commands; Dhcp Client; Ip Dhcp Client-Identifier - SMC Networks SMC6724L3 Management Manual

DHCP Commands

These commands are used to configure Dynamic Host Configuration
Protocol (DHCP) client, relay, and server functions. You can configure any
VLAN interface to be automatically assigned an IP address via DHCP.
This switch can be configured to relay DHCP client configuration requests
to a DHCP server on another network, or you can configure this switch to
provide DHCP service directly to any client.
Command
Group

DHCP Client

DHCP Relay
DHCP Server
DHCP Client
Command
ip dhcp
client-identifier
ip dhcp restart
client

ip dhcp client-identifier

Use this command to specify the DCHP client identifier for the current
interface. Use the no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Function
Allows interfaces to dynamically acquire IP address
information
Relays DHCP requests from local hosts to a remote
DHCP server
Configures DHCP service using address pools or static
bindings
Function
Specifies the DHCP client identifier for this
switch
Submits a BOOTP or DHCP client request
DHCP C
OMMANDS
Page
4-102
Mode Page
IC
PE
4-97
4-97
4-99
4-97
4-98