Chapter 41: Ip Interface Commands; Basic Ip Configuration; Table 41-1 Ip Interface Commands; Table 41-2 Basic Ip Configuration Commands - SMC Networks TigerStack II SMC8926EM Management Manual

24/48-port stackable layer 3 gigabit switch
Hide thumbs Also See for TigerStack II SMC8926EM:
Table of Contents

Advertisement

Chapter 41: IP Interface Commands

An IP address may be used for management access to the router over your network
or to connect the switch to existing IP subnets. An IPv4 address is obtained via
DHCP by default for VLAN 1. You can also manually configure a new address for
other VLANs on the router to enable management access through these VLANs or
to connect the router to existing IP subnets. You can manually configure a specific
IPv4 or IPv6 address, or direct the router to obtain an IPv4 address from a BOOTP
or DHCP server when it is powered on. Both IP Version 4 and 6 addresses can be
defined and used simultaneously to access the router. An IPv6 address can either
be manually configured or dynamically generated. You may also need to a establish
an IPv4 or IPv6 default gateway between this device and management stations or
other devices that exist on another network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect
subnetworks to the enterprise network.
Command Group

Basic IP Configuration

Address Resolution
Protocol (ARP)
Basic IP Configuration
This section describes commands used to configure IP addresses for VLAN
interfaces on the switch.
Command
IP Version 4
ip address
ip default-gateway
show ip interface
show ip redirects
ping

Table 41-1 IP Interface Commands

Function
Configures the IP address for interfaces and the gateway router
Configures static, dynamic and proxy ARP service

Table 41-2 Basic IP Configuration Commands

Function
Sets the IP address for the current interface
Defines the default gateway through which this router can reach
other subnetworks
Displays the IP settings for this device
Displays the default gateway configured for this device
Sends ICMP echo request packets to another node on the network NE, PE
Page
41-1
41-32
Mode
Page
IC
41-3
GC
41-4
PE
41-5
PE
41-5
41-6
41-1

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TigerStack II SMC8926EM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Tigerstack ii smc8950em8926em8950em

Table of Contents