Time Commands - SMC Networks SMC6724L3 Management Manual

Example
The following example shows that system logging is enabled, the message
level for flash memory is "errors" (i.e., default level 3 - 0), the message
level for RAM is "debugging" (i.e., default level 7 - 0), and lists one sample
error
Console#show logging flash
Syslog logging: Enable
History logging in FLASH: level errors
[0] 0:0:5 1/1/1
"PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[0] 0:0:5 1/1/1
"PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#

Time Commands

The system clock can be dynamically set by polling a set of specified time
servers (NTP or SNTP), or by using information broadcast by local time
servers.
Command
sntp client
sntp server
sntp poll
sntp broadcast
client
show sntp
clock timezone
Function
Accepts time from specified time servers
Specifies one or more time servers
Sets the interval at which the client polls for time GC
Accepts time from any time broadcast server
Shows current SNTP configuration settings
Sets the time zone for the switch's internal clock GC
S M
YSTEM ANAGEMENT
C
OMMANDS
Mode Page
GC 4-42
GC 4-43
4-44
GC 4-45
NE, 4-45
PE
4-46
4-41