Ip Routing Commands - SMC Networks SMC6724L3 Management Manual

Command Mode
Interface Configuration (VLAN)
Command Usage
Proxy ARP allows a non-routing device to determine the MAC address
of a host on another subnet or network.
Example
Console(config)#interface vlan 3
Console(config-if)#ip proxy-arp
Console(config-if)#

IP Routing Commands

After you configure network interfaces for this router, you must set the
paths used to send traffic between different interfaces. If you enable
routing on this device, traffic will automatically be forwarded between all
of the local subnetworks. However, to forward traffic to devices on other
subnetworks, you can either configure fixed paths with static routing
commands, or enable a dynamic routing protocol that exchanges
information with other routers on the network to automatically determine
the best path to any subnetwork.
This section includes commands for both static and dynamic routing.
These commands are used to connect between different local subnetworks
or to connect the router to the enterprise network.
Command Group Function
Global Routing
Configuration
Routing
Information
Protocol (RIP)
Open Shortest
Path First (OSPF)
Configures global parameters for static and dynamic
routing, displays the routing table, and statistics for
protocols used to exchange routing information
Configures global and interface specific parameters for
RIP
Configures global and interface specific parameters for
OSPF
IP R C
OUTING OMMANDS
Page
4-226
4-231
4-244
4-225