Global Routing Configuration; Ip Routing - SMC Networks SMC6724L3 Management Manual

C L
OMMAND INE

Global Routing Configuration

Command

ip routing

ip route
clear ip route
show ip route
show ip traffic
ip routing
Use this command to enable IP routing. Use the no form to disable IP
routing.
Syntax
ip routing
no ip routing
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• The command affects both static and dynamic unicast routing.
• If IP routing is enabled, all IP packets are routed using either static
routing or dynamic routing via RIP or OSPF, and other packets for all
non-IP protocols (e.g., NetBuei, NetWare or AppleTalk) are switched
based on MAC addresses. If IP routing is disabled, all packets are
switched, with filtering and forwarding decisions based strictly on
MAC addresses.
Example
Console(config)#ip routing
Console(config)#
4-226
I
NTERFACE
Function
Enables static and dynamic IP routing
Configures static routes
Deletes specified entries from the routing table PE
Displays specified entries in the routing table
Displays statistics for IP, ICMP, UDP, TCP and
ARP protocols
Mode Page
GC 4-226
GC 4-227
4-228
PE 4-228
PE 4-229