Show Ip Igmp Interface - SMC Networks SMC6724L3 Management Manual

Command Mode
Interface Configuration (VLAN)
Command Usage
• All routers on the subnet must support the same version. However, the
multicast hosts on the subnet may support either IGMP version 1 or 2.
• The switch must be set to version 2 to enable the ip igmp
max-resp-interval (page 4-208).
Example
The following configures the switch to use IGMP Version 1 on the
selected interface:
Console(config-if)#ip igmp version 1
Console(config-if)#

show ip igmp interface

Use this command to show the IGMP configuration for a specific VLAN
interface or for all interfaces.
Syntax
show ip igmp interface [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
M F
ULTICAST ILTERING
C
OMMANDS
4-211