(5) Dismounting of timing belt motor assembly
Dismount the timing belt motor assembly (i.e.. carriage stepper motor) as follows.
STEP 1. Dismount the M-3210 printer mechanism in accordance with paragraph 3.3 (1)
above.
STEP 2. Untie the wire band securing the bundle of lead wires supplying signals to the
timing belt motor. (See Fig. 3.13.)
STEP 3. Remove the four cup screws (M2.5x 4) securing the timing belt motor assem
bly to the motor heat sink. (See Fig. 3.13.)
OS (M2.5X4)
Timing belt motor assy
Wire band
Motor heat sink
Fig. 3.13 Dismounting of Timing Belt Motor Assy
STEP 4. Unsolder the six lead wires for the timing belt motor from the terminal board.
(See Fig. 3.14.)
STEP 5. Remove the timing belt motor assembly.
REV. A
3-12