Roll Regi Rubber - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.5.5 ROLL REGI RUBBER

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the FUSER ASSY. (p.253)
3. Remove the COVER REAR. (p.167)
4. Remove the FAN MAIN. (p.293)
5. Remove the CHUTE TRANSFR. (p.255)
6. Remove the 150 FEEDER ASSY. (p.211)
7. Remove the two SPRINGs REGI mounted on the left and right of the 150
FEEDER ASSY and hitched on the CHUTE REGI and ROLL REGI RUBBER.
8. Remove the E ring securing the GEAR REGI RUBBER to the ROLL REGI
RUBBER, and remove the GEAR REGI RUBBER.
9. Remove the E ring securing the BEARING REGI LEFT to the ROLL REGI
RUBBER.
10. Draw out the BEARING REGI LEFT and turn, disengage the cut portion of the
BEARING REGI LEFT from the projection of the CHUTE REGI, and remove the
BEARING REGI LEFT from the ROLL REGI RUBBER. (NOTE 1)
11. Remove the E-ring retaining the CLUTCH REGI, and shift the CLUTCH REGI in
the direction of the arrow.
12. Draw out the BEARING REGI RIGHT and turn, disengage the cut portion of the
BEARING REGI RIGHT from the projection of the CHUTE REGI, and remove
the BEARING REGI RIGHT from the ROLL REGI RUBBER. (NOTE 1)
13. Move the ROLL REGI RUBBER as indicated by the arrow, and remove it from
the 150 FEEDER ASSY.
In removal, take care not to hold any rubber portion of the ROLL
C A U T I O N
REGI RUBBER.
Disassembly and Assembly
12)
Note 1)
10.1mm
HOOK
SPRING REGI
BEARING REGI
RIGHT
8)
GEAR REGI
7)
Figure 4- 43. ROLL REGI RUBBER Removal
150 Paper Feeder
Note 2) Note 1)
HARNESS
ASSY TONER 2
SPRING REGI
HOOK
D cut
SPRING REGI
ROLL REGI RUBBER
13)
SPRING REGI
CLUTCH REGI
Revision C
10)
8.7mm
BEARING REGI
LEFT
9)
11)
JG3034AA
217
Confidential