Removing an MX2020 SFB
Copyright © 2015, Juniper Networks, Inc.
To remove an SFB (see
Figure 235 on page
NOTE:
You can remove the SFB as a unit.
CAUTION:
Before removing an SFB, ensure that you know how to operate
the ejector handles properly to avoid damage to the equipment.
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Open the ejector handles outward simultaneously to unseat the SFB.
3.
Grasp the ejector handles, and slide the SFB about halfway out of the chassis.
4.
Place one hand underneath the SFB to support it, and slide it completely out of the
5.
chassis.
Place the SFB on the antistatic mat or into an antistatic bag.
6.
If you are not replacing the SFB immediately, install a blank panel over the empty slot.
7.
Chapter 25: Replacing Components
496):
495