Figure 96: Loading The Mx2020 Router Into The Rack - Juniper MX2020 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.
NOTE: If you are installing the MX2020 router into a network cabinet,
make sure that no hardware, device, rack, or cabinet component obstructs
the 45-U rack space from access during installation.
Using the pallet jack, lift the chassis approximately 0.25 in. (0.6 cm) above the surface
9.
of the mounting shelf, and position it as close as possible to the shelf.
Remove the shipping brackets that are attached to the pallet jack attachment and
10.
chassis, and set them aside.
Grasping the handles on the shipping covers, carefully slide the router onto the
11.
mounting shelf so that the bottom of the chassis and the mounting shelf overlap by
approximately 2 inches. Continue sliding the router until the front-mounting flanges
contact the rack rails (depending on your type of installation). The shelf ensures that
the holes in the front-mounting flanges of the chassis align with the holes in the rack
rails (see Figure 96 on page

Figure 96: Loading the MX2020 Router into the Rack

M X2
20
0
LC
CB 10 9 10
-RE PSM 11 12
13
0 11 14 15
LC SFB 0 16 17
1 2
0 3
0 12 4 5
6 7
8
1 1
13
2 2 MAS RE
14 TER 0
ONLI NE 1 RE
3 OFFL INE
3 15
4
4 16
5 5
17
6 6
18
7
7 SFB 19 LC
8 CB -RE
1
LC
9
223).
Chapter 18: Installing the Router
223