Replacing An Mx2020 Extended Craft Interface; Removing An Mx2020 Extended Craft Interface; Figure 205: Installing The Craft Interface - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing an MX2020 Extended Craft Interface

Removing an MX2020 Extended Craft Interface

452
Tighten the screws on the left and right corners of the craft interface faceplate by
5.
using the Torx (T10) screwdriver.
Reattach any external devices connected to the craft interface.
6.

Figure 205: Installing the Craft Interface

0
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface on page 283
MX2020 Craft Interface Description on page 37
MX2020 Craft Interface Serial Number Label
Removing an MX2020 Extended Craft Interface on page 452
1.
Installing an MX2020 Extended Craft Interface on page 453
2.
To remove the extended craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Detach any external devices connected to the craft interface.
2.
Flip the extended craft interface panel up to access the ribbon cable. Use two fingers
3.
to squeeze the release latches on the sides of the connector to disconnect it from the
backside of the extended craft interface.
Remove the screws from the top corners on each side of the extended craft interface
4.
using a 4-mm Allen wrench.
19
Figure 206 on page
Copyright © 2015, Juniper Networks, Inc.
453):