Tools Required To Install The Mx2020 Router Using A Pallet Jack; Tools Required To Install The Mx2020 Router Using A Router Transport Kit - Juniper MX2020 Hardware Manual

Tools Required to Install the MX2020 Router Using a Pallet Jack

Related
Documentation

Tools Required to Install the MX2020 Router Using a Router Transport Kit

Copyright © 2015, Juniper Networks, Inc.
Unpacking the Router Transport Kit on page 201
Verifying the MX2020 Parts Received on page 199
MX2020 Router Overview on page 3
To install the router using a pallet jack with attachment, you need the following tools
and equipment:
Standard pallet jack (not provided)
Pallet jack attachment—MX2000-PLLT-JCK-ADPTR
Front component shipping covers
Rear component shipping covers
Phillips (+) screwdrivers, numbers 1, 2, and 3
9/16-in. or 14 mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
ESD wrist strap
Antistatic mat
Overview of Preparing the Site for the MX2020 Router on page 103
Removing Components from the MX2020 Router Chassis Before Installing It In a Rack
on page 209
Installing the MX2020 Router Using a Pallet Jack with Attachment on page 220
Reinstalling Components in the MX2020 Chassis After Installing It In a Rack on page 236
To install the router using a router transport kit, you need the following tools and
equipment:
Router transport kit—MX2K-TRNSPRT-KIT
Front component shipping covers
Rear component shipping covers
Phillips (+) screwdrivers, numbers 1, 2, and 3
1/2-in. (12.7 mm) drive ratchet
1/4-in. (6.35 mm) torque-controlled driver or socket wrench to tighten the nuts on the
router transport kit
1-1/8-in. (28.57 mm) torque-controlled driver or socket wrench to tighten router
transport kit winch mechanism
Chapter 15: Installation Overview
191