Removing The Mx2020 Dc Cable Manager; Figure 192: Removing The Standard Lower Cable Manager - Juniper MX2020 Hardware Manual

Removing the MX2020 DC Cable Manager

Copyright © 2015, Juniper Networks, Inc.
To remove the lower cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the lower cable manager cover, and remove it.
2.
Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the
3.
lower cable manager.
Grasp the lower cable manager, and pull it straight out from the studs on the front of
4.
the chassis.

Figure 192: Removing the Standard Lower Cable Manager

To remove the standard DC cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp the DC cable manager, lift up and pull straight out from the DC PDM on the rear
2.
of the chassis.
Place the DC cable manager into an electrostatic bag and set it aside.
3.
Chapter 25: Replacing Components
Figure 192 on page 439):
Figure 193 on page 440):
439