MX2020 3D Universal Edge Router Hardware Guide
Powering Off the DC-Powered MX2020 Router
Related
Documentation
528
NOTE:
After powering off a PSM, wait at least 60 seconds before turning it
back on.
To power off the router:
On the external management device connected to the CB-RE, issue the
1.
halt both-routing-engines
the Routing Engine cleanly, so their state information is preserved. If the router contains
only one CB-RE, issue the
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
2.
has halted. For more information about the command, see the
and Services Command Reference
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Move the DC power switch on the DC PSM faceplate for each DC PSM to the off (
4.
position, and move the DC circuit breaker from the power source input for each DC
PDM to the (
) position.
OFF
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Grounding the MX2020 Router on page 247
Powering On the DC-Powered MX2020 Router on page 273
operational mode command. The command shuts down
command.
request system halt
.
Copyright © 2015, Juniper Networks, Inc.
request system
Junos OS System Basics
)
O