MX2020 3D Universal Edge Router Hardware Guide
Installing an MX2020 SFB
496
Figure 235: Removing an SFB
0
OK/FAIL
To install an SFB (see
Figure 165 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the SFB from the electrostatic bag.
2.
Carefully align the sides of the SFB with the guides inside the chassis.
3.
Slide the SFB into the chassis until you feel resistance, carefully ensuring that it is
4.
correctly aligned.
Grasp both ejector handles, and gently close them inward simultaneously until the
5.
SFB is fully seated.
Check the LEDs on the SFB faceplate to verify that it is functioning normally.
6.
The green
LED should light steadily a few minutes after the SFB is installed.
OK/FAIL
If the
OK/FAIL
LED is red, remove and install the SFB again. If the
lights steadily, the SFB is not functioning properly. Contact your customer support
representative. See
"Contacting Customer Support" on page
Check the status of the SFB using the
7.
user@host> show chassis environment sfb
19
323):
show chassis environment sfb
Copyright © 2015, Juniper Networks, Inc.
OK/FAIL
LED still
549.
command: