Installing The Mx2020 Router Using A Pallet Jack With Attachment; Figure 93: Installing Pallet Jack Attachment Onto Pallet Jack - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing the MX2020 Router Using a Pallet Jack with Attachment

220
Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
5.
Tighten the torque fasteners by using a 9/16-in. (14 mm) socket wrench to secure the
6.
brackets on the pallet jack attachment to the pallet jack (see

Figure 93: Installing Pallet Jack Attachment onto Pallet Jack

Overview of Preparing the Site for the MX2020 Router on page 103
Tools Required to Install the MX2020 Router Using a Pallet Jack on page 191
Installing the MX2020 Router Using a Pallet Jack with Attachment on page 220
Before installing the router, you must remove all components (see
Components from the MX2020 Router Chassis Before Installing It In a Rack" on page
To install the router using a pallet jack with attachment:
Ensure that the rack or cabinet is in its permanent location and is secured to the
1.
building. Ensure that the installation site allows adequate clearance for both airflow
and maintenance.
Reinstall the front and rear shipping covers to help guide the chassis during installation.
2.
Place the pallet jack attachment across both legs and secure the attachment to the
3.
pallet jack.
Figure 93 on page
"Removing
Copyright © 2015, Juniper Networks, Inc.
220).
209).