Copyright © 2015, Juniper Networks, Inc.
Place one hand underneath the SFB to support it, and slide it completely out of the
5.
chassis. Place it on the antistatic mat.
CAUTION:
The weight of the SFB is concentrated in the back end. Be
prepared to accept the full weight—up to 12 lb (5.45 kg)—as you slide the
SFB out of the chassis.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each SFB.
6.
Figure 90: Removing an SFB
0
OK/FAIL
19
Chapter 18: Installing the Router
215