Installing The Mx2020 Lower Cable Manager; Figure 193: Removing The Standard Dc Cable Manager - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide

Installing the MX2020 Lower Cable Manager

440

Figure 193: Removing the Standard DC Cable Manager

D
NOTE: To accommodate additional clearance, you may order an extended
lower cable manager from Juniper Networks.
To install the lower cable manager (see
Position the lower cable manager on the studs on the lower front of the chassis, just
1.
below the MPCs.
Insert the screws into the corners in the lower cable manager onto the studs on the
2.
chassis.
Using a Phillips (+) screwdriver (number 1 or 2), tighten the mounting screws securely.
3.
Replace the cable manager cover, and secure it with the two captive screws.
4.
Figure 162 on page 315):
Copyright © 2015, Juniper Networks, Inc.