Figure 92: Removing A Cb-Re - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation
218
CAUTION: The weight of the CB-RE is concentrated in the back end. Be
prepared to accept the full weight—up to 15 lb (6.8 kg)—as you slide the
CB-RE out of the chassis.
When the CB-RE is out of the chassis, do not hold it by the ejector handles,
bus bars, or edge connectors. They cannot support its weight.
CAUTION: Do not stack CB-REs on one another after you remove them.
Place each component on an antistatic mat resting on a stable, flat surface.

Figure 92: Removing a CB-RE

0
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Overview of Preparing the Site for the MX2020 Router on page 103
Tools Required to Install the MX2020 Router Using a Router Transport Kit on page 191
Installing the MX2020 Router Using a Router Transport Kit on page 229
Reinstalling Components in the MX2020 Chassis After Installing It In a Rack on page 236
19
Copyright © 2015, Juniper Networks, Inc.