Figure 127: Mx2020 Dc Power Supply Module Front View - Juniper MX2020 Hardware Manual

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Verify that the and/or
4. INP0
Figure 127 on page 267).
NOTE: If you are connecting two feeds,
PSM will be lit green steadily.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
5.
the strap to one of the ESD points on the chassis.
Move the switch to the on (
6.
Verify that the PWR OK
7.
Module LEDs" on page 98
Repeat Steps 1 through
8.

Figure 127: MX2020 DC Power Supply Module Front View

NOTE: Each PSM slot not occupied by a DC PSM must be covered by a
PSM blank panel.
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Powering On the DC-Powered MX2020 Router on page 273
Chapter 19: Connecting the Router to Power
LEDs on the PSM are lit green steadily (see
INP1
) position.
|
LED is lit green steadily. See
for information on MX2020 DC PSM LEDs.
7 for installing PSMs in slots
INP0 and INP1 , both LEDs on the
"MX2020 DC Power Supply
, , and , where required.
0 1 2
267