Figure 186: Removing The Middle Card Cage Cable Manager Air Filter - Juniper MX2020 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.
CAUTION: Do not run the router for more than 2 minutes without the air
filter in place.
Open the cable manager door to get access to the air filter.
4.
Grasp the air filter, and pull the air filter straight out from the access door, (see
5.
Figure 186 on page 433).

Figure 186: Removing the Middle Card Cage Cable Manager Air Filter

0
To remove the PSM air filter—MX2000-FLTR-PWR:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws located on either side of the air filter and pull slightly
2.
out of the chassis.
CAUTION: Do not run the router for more than 2 minutes without the air
filter in place.
Grasp the PSM air filter, and pull the air filter straight out from the chassis.
3.
Slide the air filter out of the chassis as shown in
4.
NOTE: The AC–powered MX2020 router has the same air filter.
19
Figure 187 on page
Chapter 25: Replacing Components
434.
433