Juniper MX2020 Hardware Manual page 260

MX2020 3D Universal Edge Router Hardware Guide
228
CAUTION: Do not raise the chassis above 1 in. (2.54 cm). This will ensure
the router will not tilt when transporting, which can result in injury or
damage to the router.
Turn the four wheels on the router transport kit toward the rear of the chassis.
4.
Grasping the handles on the shipping covers, carefully guide the chassis down the
5.
crate ramp to the rack location.
WARNING: Do not push or pull the router fast during transporting. Using
excessive speed can cause the wheels to turn abruptly and tilt the router
over.
CAUTION: Do not lift the router using the handles on the shipping covers.
Use these handles only to help position the router.
Position the router transport platform directly under the router, aligning the router
6.
transport platform with the bottom of the chassis by adjusting the four leveling mounts.
NOTE: The router transport platform height can be adjusted between
0.25 in. (0.6 cm) to a maximum of 4 in. (10.16 cm).
Secure the router transport platform to the router transport mounting plates using
7.
the four latch locks (see Figure 100 on page 229).
Copyright © 2015, Juniper Networks, Inc.