Juniper MX2020 Hardware Manual page 229

Copyright © 2015, Juniper Networks, Inc.
To unpack the router:
Move the shipping crate to an ESD approved staging area as close to the installation
1.
site as possible, where you have enough room to remove the components from the
chassis. While the chassis is bolted to the shipping pallet, you can use a forklift or
pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate and set it aside.
4.
NOTE: If you ordered a router transport kit, the shipping crate door is used
as a ramp to guide the MX2020 out of the crate.
Using a two person team, slide the remainder of the shipping crate off the pallet (see
5.
Figure 79 on page 198).
Remove the foam covering the top of the router.
6.
Remove the large rack mounting tray, pallet jack attachment, accessory box and the
7.
Quick Start installation instructions.
Chapter 16: Unpacking the Router
197