Removing the CB-REs Before Installing the MX2020 Router
Copyright © 2015, Juniper Networks, Inc.
CAUTION:
The weight of the MPC is concentrated in the back end. Be
prepared to accept the full weight—up to 18.35 lb (8.32 kg)—as you slide
the MPC out of the ADC.
When the MPC is out of the ADC, do not hold it by the knobs, bus bars, or
edge connectors. They cannot support its weight.
Do not stack MPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
Figure 91: Removing an MPC without the ADC
0
10
11
12
13
14
15
16
17
18
To remove a CB-RE (see
Figure 92 on page
Have ready an antistatic mat for the CB-RE. Also have ready rubber safety caps for
1.
each SFP that uses an optical interface on the CB-RE that you are removing.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Open both ejector handles simultaneously to unseat the CB-RE.
3.
Grasp the handles, and slide the CB-RE straight out of the card cage halfway.
4.
Place one hand around the front of the CB-RE and the other hand under it to support
5.
it. Slide the CB-RE completely out of the chassis, and place it on the antistatic mat
or in the electrostatic bag.
Chapter 18: Installing the Router
218):
217