Removing the MX2020 Extended DC Cable Manager
Copyright © 2015, Juniper Networks, Inc.
Figure 198: Removing the Extended Lower Cable Manager
To remove the extended DC cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Using a Phillips (+) screwdriver (number 1 or 2), loosen the two captive screws on the
2.
DC cable manager.
Grasp the extended DC cable manager, lift up and pull straight out from the DC PDM
3.
on the rear of the chassis.
Place the extended DC cable manager into an electrostatic bag and set it aside.
4.
Chapter 25: Replacing Components
Figure 199 on page
446):
445