Removing The Power Supply Modules Before Installing An Mx2020; Router; Figure 84: Removing An Ac Power Distribution Module Before Installing The; Figure 85: Removing A Dc Power Distribution Module Before Installing The - Juniper MX2020 Hardware Manual

Removing the Power Supply Modules Before Installing an MX2020 Router
Copyright © 2015, Juniper Networks, Inc.
Figure 84: Removing an AC Power Distribution Module Before Installing
the MX2020 Router
Figure 85: Removing a DC Power Distribution Module Before Installing
the MX2020 Router
To remove the AC or DC PSMs (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
On an AC-powered router, move the AC power switch on each PSM to the off (
2.
position. On a DC-powered router, move the DC power switch on each PSM to the off
( ) position.
O
Chapter 18: Installing the Router
Figure 86 on page 212 and Figure 87 on page 213):
)
O
211