Installing the Lower MX2020 Extended Cable Manager
Copyright © 2015, Juniper Networks, Inc.
Figure 200: Installing the MX2020 Upper Extended Cable Manager
To install the lower extended cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Position the lower extended cable manager on the studs below the lower card cage.
2.
Attach the lower extended cable manager using eight screws as shown in
3.
Figure 201 on page
448.
Replace the cable manager cover, and secure it with the two captive screws.
4.
Chapter 25: Replacing Components
19
Figure 201 on page
448):
447