Installing An Mx2020 Cb-Re; Figure 177: Removing A Cb-Re - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide

Installing an MX2020 CB-RE

420

Figure 177: Removing a CB-RE

0
To install a CB-RE (see Figure 152 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the CB-RE from the electrostatic bag.
2.
Carefully align the sides of the CB-RE with the guides inside the chassis.
3.
Slide the CB-RE into the chassis until you feel resistance, carefully ensuring that it is
4.
correctly aligned.
Grasp both ejector handles, and gently close them inward simultaneously until the
5.
CB-RE is fully seated.
Check the LEDs on the CB-RE faceplate to verify that it is functioning normally.
6.
The green LED should light steadily a few minutes after the CB-RE is
OK/FAIL
installed.
If the LED is red, remove and install the CB-RE again. If the
OK/FAIL
still lights steadily, the CB-RE is not functioning properly. Contact your customer
support representative. See
Check the status of the CB-RE using the
7.
19
303):
"Contacting Customer Support" on page
show chassis environment cb
Copyright © 2015, Juniper Networks, Inc.
LED
OK/FAIL
549.
command: