Figure 147: Installing The Air Filter - Juniper MX2020 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.
Open the fan tray and air filter access door, located at the bottom of the chassis.
3.
Grasp the handle on the air filter and insert into the chassis until it stops, (see
4.
Figure 147 on page 297).
Close the access door and tighten the two captive screws to secure.
5.
Lower the cable manager back into position, and rearrange the cables in the cable
6.
manager.

Figure 147: Installing the Air Filter

To install the middle card cage cable manager air filter—MX2020-MID-FLTR-PNL-S:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Move the cables from the middle card cage cable manager, if necessary.
2.
Loosen the two captive screws located on the front of the middle card cage cable
3.
manager door, and open.
CAUTION: Do not run the router for more than 2 minutes without the air
filter in place.
Grasp the air filter, and slide the bottom of the air filter into the channel of the access
4.
door, (see Figure 148 on page
Chapter 22: Installing and Replacing Components
D
298).
297