Figure 171: Upper And Lower Cable Manager Cable Routing - Juniper MX2020 Hardware Manual

Action
Copyright © 2015, Juniper Networks, Inc.
On a regular basis:
Use an upper cable manager and a lower cable manager (shown in
Figure 171 on page 339) to support cables and prevent cables from dislodging or
developing stress points.

Figure 171: Upper and Lower Cable Manager Cable Routing

LC 10 11 12 13 14 15 16
NOTE: The MX2020 supports both standard and extended upper and lower
cable management.
Place excess cable out of the way in the upper and lower cable managers. Do not allow
fastened loops of cable to dangle from the connector or cable manager because this
stresses the cable at the fastening point. Putting fasteners on the loops helps to
maintain their shape.
Keep the cable connections clean and free of dust and other particles, which can cause
drops in the received power level. Always inspect cables and clean them if necessary
before connecting an interface.
Label both ends of the cables to identify them.
17 18 19
Chapter 23: Maintaining Components
339