Copyright © 2015, Juniper Networks, Inc.
Figure 188: Installing the Air Filter
To install the middle card cage cable manager air filter—MX2020-MID-FLTR-PNL-S:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Move the cables from the middle card cage cable manager, if necessary.
2.
Loosen the two captive screws located on the front of the middle card cage cable
3.
manager door, and open.
CAUTION:
Do not run the router for more than 2 minutes without the air
filter in place.
Grasp the air filter, and slide the bottom of the air filter into the channel of the access
4.
door, (see
Figure 148 on page
D
298).
Chapter 25: Replacing Components
435