Installing The Mx2020 Craft Interface; Figure 149: Installing The Psm Air Filter - Juniper MX2020 Hardware Manual

Related
Documentation

Installing the MX2020 Craft Interface

Copyright © 2015, Juniper Networks, Inc.

Figure 149: Installing the PSM Air Filter

Maintaining the MX2020 Air Filter on page 341
Removing the MX2020 Air Filter on page 431
To install the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
3.
keyed and can be inserted only one way.
Align the bottom of the craft interface with the sheet metal above the card cage, and
4.
press it into place.
Tighten the screws on the left and right corners of the craft interface faceplate by
5.
using the Torx (T10) screwdriver.
Reattach any external devices connected to the craft interface.
6.
Chapter 22: Installing and Replacing Components
Figure 150 on page 300):
299