Connecting The Router To The Network; Connecting The Mx2020 Router To Management And Alarm Devices; Connecting The Mx2020 Router To A Network For Out-Of-Band Management; Figure 130: Out-Of-Band Management Port - Juniper MX2020 Hardware Manual

CHAPTER 20

Connecting the Router to the Network

Connecting the MX2020 Router to Management and Alarm Devices

Connecting the MX2020 Router to a Network for Out-of-Band Management

Copyright © 2015, Juniper Networks, Inc.
Connecting the MX2020 Router to Management and Alarm Devices on page 275
Connecting the MX2020 Router to a Network for Out-of-Band Management on page 278
Connecting the MX2020 Router to a Console or Auxiliary Device on page 279
Connecting an MX2020 Router to an External Alarm-Reporting Device on page 280
Connecting the Alarm Relay Wires to the MX2020 Craft Interface on page 282
Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface on page 283
Connecting MPC or MIC Cables to the MX2020 Router on page 284
Connecting the MX2020 Router to a Network for Out-of-Band Management on page 275
Connecting the MX2020 Router to a Console or Auxiliary Device on page 276
Connecting an MX2020 Router to an External Alarm-Reporting Device on page 277
To connect the CB-RE to a network for out-of-band management, connect an Ethernet
cable with RJ-45 connectors to the
cable is provided with the router. To connect to the
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the CB-RE interface.
MGMT
Table 83 on page 276 describes the Ethernet ports.
Plug the other end of the cable into the network device.
3.

Figure 130: Out-of-Band Management Port

1 2 3
port on the CB-RE interface. One Ethernet
MGMT
port on the CB-RE interface:
MGMT
(Figure 131 on page 276
Figure 130 on page 275
shows the connector) into
shows the port.
275