MX2020 3D Universal Edge Router Hardware Guide
298
Figure 148: Installing the Middle Card Cage Cable Manager Air Filter
0
Push the air filter in place, close the door, and tighten the two captive screws.
5.
Replace the cables in the middle card cage cable manager, if necessary.
6.
To install the PSM air filter—MX2000-FLTR-PWR:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the air filter is right side up.
2.
Grasp the PSM air filter and insert into the chassis until it stops, (see
3.
Figure 149 on page
299).
Tighten the two captive screws to secure.
4.
NOTE:
The AC-powered MX2020 router has the same air filter.
19
Copyright © 2015, Juniper Networks, Inc.