Removing the MX2020 Craft Interface
Installing the MX2020 Craft Interface
Copyright © 2015, Juniper Networks, Inc.
To remove the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Detach any external devices connected to the craft interface.
2.
Loosen the captive screws at the left and right corners of the craft interface faceplate
3.
by using the Torx (T10) screwdriver.
Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
4.
Disconnect the ribbon cable from the back of the faceplate by gently pressing on both
5.
sides of the latch with your thumb and forefinger. Remove the craft interface from
the chassis.
Figure 204: Removing the Craft Interface
0
To install the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
3.
keyed and can be inserted only one way.
Align the bottom of the craft interface with the sheet metal above the card cage, and
4.
press it into place.
Chapter 25: Replacing Components
Figure 204 on page
451):
19
Figure 150 on page
300):
451