Basler BE1-11g Instruction Manual page 702

690
Software
Version and Date
3.09.00, Apr-15
3.10.00, Jun-15
3.11.00, Nov-15
3.12.00, Apr-16
3.14.00, Jul-16
3.15.00, Aug-16
3.17.00, May-17
3.17.01, Jul-17
Manual
Revision and Date
—, Jun-09
A, Aug-09
B, Oct-09
C, Jul-10
D, Nov-10
Revision History
•
Maintenance release
•
Maintenance release
•
Added support for BE1-11g firmware version 2.09.00
•
Added Sequence of Events filtering
•
Changed to allow uploading of newer security settings into older
devices
•
Improved 43 switches screen layout
•
Changed to prevent Offline Simulator button from disabling after
sending settings to the device
•
Added support for BE1-11g firmware version 2.10.00
•
Corrected duplication of style number options in settings printout
•
Maintenance release
•
Security Patch: Corrected issue in which Port Access Device
Security setup for USB was not being uploaded to units with
hardware version AK and later. See the Security and
BESTCOMSPlus Software chapters.
•
Added support for BE1-11g firmware version 2.11.01
•
Added authentication and encrypted communication
•
Improved target reporting for the 21, 24, and 32 elements
•
Enabled detection of a unit connected through USB when
unsecured access is set to none
•
Improved communication to devices
•
Updated USB driver installer for improved Windows 10
compatibility
•
Corrected issue with settings printout
Table 271. Instruction Manual Revision History
•
Initial release
•
Renamed "Neutral Current" option to "Ground Current" in Figure
1-1, Style Chart
•
Updated Figure 3-25, Basler Electric Device Package Uploader
•
Added Note #3 to Style Chart in Section 1 "If Phase Current
choice is 1, Ground Current choice must be B"
•
Improved listing of Standards and CE Compliance in Section 1,
General Information, General Specifications
•
Section 1: Added statement about an evaluation copy of
BESTWAVEPlus™ being included on the product CD
•
In Section 9, changed 27 and 59 time delays from "0 or 50 to
600,000 ms" to "50 to 600,000 ms"
•
Replaced Figures 13-17, 13-27, and 13-28. Added a connection
between C16 (VN) and C14 (VB)
•
Added P Case Option and IEC 61850 Ethernet Protocol option
to the Style Chart in Section 1
•
Added EN 61000-6-2 and EN 61000-6-4 under General
Specifications, CE Compliance in Section 1
•
Added DNP Certification, IEC 61850 Certification, and IP Class
under General Specifications in Section 1
•
Added Display Units in Section 4
•
Added Configure Ethernet Port under Ethernet in Section 5
•
Added Breaker Status, and 86 Lockout Status under Status in
Section 8
•
Added Figure 13-3, H1 Panel-Mount Case Dimensions
9424200994 Rev U
Change
Change
BE1-11g