500 Hour Maintenance; Tip Wipe Assembly - HP Designjet 3D Service Manual

500 Hour maintenance

Preventive Maintenance Alerts will be displayed on the workstation at the
500 hour time interval as a reminder to perform preventive maintenance.
See

Tip wipe assembly

The tip wipe assembly should be replaced approximately every 500 hours.
1. Completely power down the printer.
2. Move the head to the right of the printer to gain access to the tip wipe
3. Remove the tip wipe assembly by lifting the assembly up and out of the
-60
Figure 36.
Figure 36: Preventive Maintenance Alert
assembly.
Figure 37: Move the toggle head to the right
printer. Discard this tip wipe assembly. See Figure 38.