5. Disconnect the material bay cable from the printer.
6. Remove the Front Panel. See
7. Remove the Electronics Bay. See
8. Using a
Remove the 7
mounting screws.
9. Using a
10. Using a
1 1. Pull the left side Y belt out from the retaining clip.
-264
Figure 217: Left side access panel mounting screw locations
Remove the 7
mounting screws.
page 175
5
⁄
" nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the right side access panel.
See
Figure 218.
Figure 218: Right side access panel mounting screw locations
5
⁄
" box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the left side. See
5
⁄
" box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the left side. See
"Removing the front panel" on page 166
"Removing the Electronics Bay" on
Figure 219.
Figure 219.