Replacing Material For Dual Material Bays - HP Designjet 3D Service Manual

6. Remove the material carriers by first pushing them in to unlatch and then
7. Place the carrier on a flat stable surface.
8. Open the carrier.
9. Rotate the spool to rewind the material, leaving 2 inches (50mm)
10. Using a cutters, cut the excess 2 inches (50mm) of material from the
1 1. Replace the material spool.
12. Close and latch the carrier.
13. Once the material carriers have been replaced press Load...
14. Select Load Model, Load Support or Load both.
15. After material has been loaded to the head press Done...
Replacing material for dual material
bays
1. From the display panel press Material... The display will show Add/
2. Press Unload...
3. Press Unload both, Unload Model or Unload Support.
4. The printer will now unload material from the head. When the material
5. Open the material bay doors by gently pressing in to release and pull-
6. Remove the material carriers by first pushing them in to unlatch and then
-48
pulling them outwards.
CAUTION: Do not push the material through the material guide
back into the carrier, doing so can cause material to break or
become tangled.
remaining at the material guide. See
Figure 28: Rewinding the material spool
material guide. leaving a blunt end.
Remove and S1(remaining%), S2(remaining%) and M1, M2
(remaining%). Asterisks will mark the currently active material bays (the
material bays that are currently loaded to the head).
has unloaded, you will need to replace the material carriers.
ing outwards.
pulling them outwards.
Figure 28.