Installing The Z Stage - HP Designjet 3D Service Manual

5
6. Using a ⁄ " socket driver or
16
stage guide rod mounting screws. See
Figure 308: Lower Z stage guide rod mounting screw locations
Remove the 2
mounting screws
5
7. Using a ⁄ " nut driver or standard screwdriver, remove the 2 upper Z
16
stage guide rod mounting screws. See
Figure 309: Upper Z stage guide rod mounting screw locations
Remove the 2
mounting screws
8. Remove the Z stage by pulling out of the printer through the chamber
door.

Installing the Z stage

1. Align the Z stage guide rods with the upper and lower mounting holes.
5
2. Using a ⁄ " socket driver or
16
Z stage guide rod mounting screws.
3. Using a 5/6" nut driver or standard screwdriver, loosely fasten the
upper Z stage guide rod mounting screws.
5
⁄ " box wrench, remove the 2 lower Z
16
Figure 308.
Figure 309.
5
⁄ " box wrench, loosely fasten the lower
16
-327