Installing The Toggle Bar - HP Designjet 3D Service Manual

Installing the toggle bar:

1. Align the toggle bar with the translator and reinstall the washer over the
2. Push the toggle assembly back into position.
3. Reinstall the lower washer and spring.
4. Using a
5. Reinstall the upper spring and washer.
6. Using a
7. Using a
8. Reinstall the model tip (right side) and support tip (left side) by pushing
9. Using a
10. Reinstall the head cover.
1 1. Power the printer up.
12. Perform calibrations. See
-232
bottom mounting post. See
Figure 167: Toggle bar alignment
Reinstall washer
Align toggle bar
7
⁄ " allen wrench, reinstall the lower spring screw.
64
7
⁄ " allen wrench, reinstall the upper spring screw.
64
7
⁄ " allen wrench, reinstall the heat shield.
64
up into place.
7
⁄ " allen wrench tighten the tip mounting screws.
64
(Figure 167)
"Offset Calibrations" on page 338