Removing The Left Side Thermal Fuse - HP Designjet 3D Service Manual

Removing the left side thermal fuse

1. Remove the top panel. See
2. Remove the side panels. See
5
3. Using a ⁄ " nut driver or standard screwdriver, remove the 4 mounting
16
screws from the left side heater panel and remove the heater panel. See
Figure 297.
Figure 297: Left side heater panel mounting screw locations
Remove the mounting
screws
4. Disconnect the LTH1 and LTH2 spade connectors by pulling outward.
See Figure 298.
Figure 298: LTH1 and LTH2 spade connector locations
Disconnect
LTH1
5. Using a standard screwdriver, remove the 2 mounting screws. See
299.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Disconnect
LTH2
Figure
-317