HP Designjet 3D Service Manual page 111

Code Description
14,55 Abort : Find home
failed, X home and X
eot both on
14,56 Abort : Find home
failed, Y home and Y
eot both on
14,57 Abort : Find home
failed, X home timeout
14,58 Abort : Find home
failed, Y home timeout
14,59 Abort : Find home
failed, X home not
tripped
14,60 Abort : Find home
failed, Y home not
tripped
14,61 Abort : Find home
failed, X home tripped
14,62 Abort : Find home
failed, Y home tripped
14,63 Abort : Find home
failed, X eot tripped
14,64 Abort : Find home
failed, Y eot tripped
Corrective Actions
1. Power cycle machine - remember to move
head away from switches.
2. X errors - Check pins and reseat connector
J505 on the I/O Board. Y errors - Check
pins and reseat connector J503 on the I/O
Board.
3. Using LED's check to see if switch state
toggles. If not, check sensor and/or
umbilical cable for X and Y cable for Y.
4. Replace the head board for X errors and
replace the Y sensors for Y.
1. Power cycle machine - remember to move
head away from switches.
2. If chatter in motor, check motor and/or
motor cable for Y, umbilical cable for X.
3. Check for obstacles obstructing X or Y
movement.
4. Using LED's check to see that the state
changes when sensor is activated. If not,
check sensor and/or umbilical cable for X
and Y cable for Y.
1. Power cycle machine - remember to move
head away from switches.
2. Using LED's check to see home toggles
when sensor is activated. If not, check
sensor and/or Umbilical Cable for X and Y
cable for Y.
3. X errors - Check pins and reseat connector
J505 on the I/O Card. Y errors - Check
pins and reseat connector J503 on the I/O
Card.
1. Power cycle machine - remember to move
head away from switches.
2. Using LED's check to see home box toggles
when sensor is activated. If not, check
sensor and/or umbilical cable for X , Y
cable for Y.
3. X errors - Check pins and reseat connector
J505 on the I/O Card. Y errors - Check
pins and reseat connector J503 on the I/O
Card.
1. Power cycle machine - remember to move
head away from switches.
2. Using LED's check to see home box toggles
when sensor is activated. If not, check
sensor and/or umbilical cable for X , Y
cable for Y.
1. X errors - Check pins and reseat connector
J505 on the I/O Card. Y errors - Check
pins and reseat connector J503 on the I/O
Card.
-95