HP Designjet 3D Service Manual page 231

Hide thumbs Also See for Designjet 3D:
Table of Contents

Advertisement

Figure 141: Heater power cable locations
Disconnect
the support
side heater
cable
9. Disconnect the toggle sensor cable from the toggle sensor.
Figure 142: Toggle sensor location
10. Disconnect the toggle sensor cable from the head board.
Figure 143: Toggle sensor cable location
Disconnect the
toggle sensor
cable from the
head board
1 1. Cut the wire tie holding the drive motor cables in place.
Disconnect the
model side
heater cable
Disconnect the toggle
sensor cable
-215

Advertisement

Table of Contents
loading

Table of Contents