HP Designjet 3D Service Manual page 100

Figure 61: Create access space for cleaning - model side shown
ii. Move idler wheel assembly by pushing with 7/64 inch
T-Handle Allen wrench against spring tension. Insert a
1/8 T-handled Allen wrench (from startup kit) into the
fixture hole. See
Figure 62: Holding access space open - model side shown
Insert 1/8 inch
T-Handle into
fixturing hole.
To create space, move Idler
assembly by pushing with 7/64
T-Handle Allen wrench against
spring tension.
Toggle
spring post
Idler wheel post
Position toggle
bar to same
side of head as
T-Handle.
Figure 62.
-84