Installing The Head Board - HP Designjet 3D Service Manual

15. Using a
Remove the head board
mounting screws

Installing the head board

1. Align the head board with the mounting holes.
2. Using a
3. Reconnect the substrate sensor cable and the 2 filament motor cables to
4. Feed the toggle sensor cable through the head board.
5. Using a
6. Reconnect the toggle sensor cable to the toggle sensor.
7. Reconnect the toggle sensor cable to the head board.
8. Reconnect the model and support heater cables.
9. Reconnect the umbilical cable.
10. Place the thermocouple wires in the wire retaining clip.
1 1. Reconnect the model and support material tubes.
12. Reinstall the air plenum.
13. Reinstall the head cover.
14. Reinstall the right side access cover.
15. Reinstall the side panels. See
16. Reinstall the top panel. See
-238
Figure 179: Rear head board cable locations
Disconnect the 3
cables
1
⁄ " nut driver or standard screwdriver, remove the 4 head
4
board mounting screws. See
Figure 180: Remove the head board mounting screws
1
⁄ " nut driver or standard screwdriver, reinstall the 4 mounting
4
screws.
the rear of the head board.
1
⁄ " nut driver or standard screwdriver, reinstall the toggle sen-
4
sor wire clips.
Figure 180.
"Installing the side panels" on page 164
"Installing the top panel" on page 162